There is small much more irritating than attempting to pay attention to your preferred audio on your ipod only to have it freeze up. With the introduction of a quantity of various designs and generations of iPods to the marketplace, it can occasionally be tough to figure out how to unfreeze your specific design of ipod. Fortunately, 1st, 2nd and third generations of the ipod Nano can be reset with a minimum number of difficulty, utilizing the exact same method.
Place your ipod Nano (2nd generation) on a flat surface area, ideally on a counter or table that will not effortlessly conduct static electrical energy.
Find the "Maintain" change on the leading of your ipod. The change is on opposite finish of the ipod Nano from exactly where you plug in your charging cord. It is a minor, skinny change that slides back again and forth.
Determine the "Menu" and "Choose" button on your ipod's scroll wheel. The scroll wheel surrounds the "Decide on" button, which is simply the unlabelled circle in the center, that which you use when selecting a menu merchandise. The "Menu" button is the component straight over the "Choose" button. If you envision your ipod Nano's scroll wheel as a clock, then the "Menu" button is at twelve o'clock.
Slide the "Maintain" button back again and forth in between "on" and "off." This is recognized as toggling. Toggle the change quickly 2 to three occasions. This stage by by itself might unfreeze the ipod. If not, move on to Phase five.
Maintain the "Menu" and "Decide on" buttons down at the identical time for roughly ten seconds. This can be relatively difficult and awkward to do devoid of pressing any of the other scroll wheel buttons, but if you place the pad of your index finger on the "Menu" button, you can normally press equally buttons with that one digit.Or else, check out employing one thumb on equally button.
Wait for the Apple logo to look. This implies the firmware is rebooting and your ipod is restarting.
No comments:
Post a Comment