Welcome to the iPodRepairSquad.com iPod Nano Gen one disassembly manual. These models are modest and fragile so make sure you use treatment as soon as managing your unit.
Items You may Need to have
- Instruments Necessary ? Soft Resources - employed to open the scenario without having scratching. Accessible at www.ipodrepairsquad.com ? Tiny Phillips head screwdriver - #00
Opening the Circumstance
? Be confident the Maintain Change is turned on. You may see orange the moment you have the Maintain in the appropriate place.
? Making use of one soft device wedge it into the aspect of the iPod. It really is desired to remain away from the Maintain Change and the headphone jack.
? Employing a facet to facet movement, loosen the iPod although gently prying up and down. It is valuable to insert two soft Instruments at when, Employing 1 to Maintain the gap open and the other to slide.
? There are numerous clips keeping the circumstance in placement, so operate your way all around and pop 1 facet off very first, then move forward to the top rated or bottom and the scenario really should snap appropriate off.
Dislodging the Battery
? Making use of a soft instrument gently pry up on the battery from the edge demonstrated. It really is held on with some adhesive so You are going to have to function about the aspect as properly.
? The moment it can be loose you ought to be able to flip the battery out but be watchful due to the fact it can be even now soldered to the logic board.
? If you happen to be changing the battery you can possibly use the soldering strategy or the twisting technique. These might be coated in separate manuals in the foreseeable future. For now depart the battery connected.
Taking away the Logic Board
? There are 4 screws to take away as proven with the Red arrows in the photograph previously mentioned. These could be coated with tape. Be cautious not to strip the screws.
Free of charge Logic Board From Clips
? Be confident to use a flat screwdriver to loosen the logic board from the 4 clips proven over so You are going to have a lot more area to function with just before you move forward to the following action.
Getting rid of the ClickWheel Ribbon
? We have identified the top rated way is to Maintain the Nano among your thumb and initial 2 fingers. You would not have significantly area to operate but it really is sufficient to get a modest flat head screwdriver in there and elevate the clip up.
? The ribbon is held in placement by a connector on the logic board (see following action.)
? The black latch wants to be flipped to the up placement as demonstrated over and then the cable can be simply eliminated. If you happen to be keeping it like demonstrated flip the latch in the direction of your thumb.
Further photograph of ClickWheel Connector referenced previously mentioned
Getting rid of the LCD
? The LCD is eliminated in the identical way as the ClickWheel. Be positive not to hurt the black clips.
? The black clips are a bit more challenging to snap back again into placement than they are to snap up, so we advise Utilizing a flat instrument so as to not set also significantly strain on any 1 level of the black clip.
LCD is Now Free of charge
Operate in reverse order to set up the Essential part you Want. If you have queries sense No cost to speak to us at customerservice@ipodrepairsquad.com or one-888-IPOD-Resolve
No comments:
Post a Comment