The ipod nano makes use of a particular synching cable---one particular aspect is a USB plug and the other an Apple proprietary plug---to connect to a personal computer. A damaged connection in the USB plug will render the cable ineffective. Fix the cable by changing the USB plug.
Points You are going to Want
- Scissors Utility knife Newspaper USB substitute plug Soldering iron Solder Electrical tape
Lower off the USB plug from the synching cable with a scissors. Make a three-inch slit in the outer insulation from the Lower end of the cable inwards with the blade of the utility knife. Pull back again the outer insulation with your fingers.
Separate the wires within the outer insulation from each and every other. Lower off any wires other than the red, white, green and black with the scissors so they would not get in the way.
Strip a fifty percent inch of insulation off the ends of the remaining wires with the wire strippers.
Spot a sheet of newspaper on a table to shield the surface area. Spot the USB alternative plug on the newspaper with the conductive pins dealing with up.
Warmth up the soldering iron for 5 minutes. Solder the uncovered end of the red wire to the leftmost speak to on the USB plug. Permit the solder cool for a minute. Solder the uncovered end of the white wire to the 2nd speak to from the left on the USB plug. Permit the solder cool for a minute.
Solder the uncovered end of the green wire to the 3rd from the left speak to on the USB plug. Permit the solder cool for a minute.
Solder the uncovered end of the black wire to the rightmost speak to on the USB plug. Permit the solder cool for a minute. Unplug the soldering iron.
Wrap a strip of electrical tape all around the uncovered ends of the wires and the make contact with pins on the USB plug. Wrap an added strip of electrical tape to added protected the two jointly.
No comments:
Post a Comment