iPod Nano Battery Replacement Tips

The ipod Nano MP3 60GB product has been enhanced so battery daily life is up to twenty hrs on a single cost. As with all electronics, the battery for this MP3 player desires recharging and will sooner or later have to be changed. Batteries can be acquired at retail and on the web merchants. Apple recommends that new batteries be put in at taking part ipod Nano merchants. Some ipod Nano end users acquire the battery and set up it at property.

Instruments Essential

2 nylon Instruments, knife or scissors are Essential for battery alternative. Light- or medium-fat guitar picks have also been advised. Metal Equipment will hurt the ipod circumstance and really should never ever be utilised. The ability to the ipod ought to be turned off ahead of starting up.

Opening the ipod

The player really should be held flat and experience up. Insert the instrument involving the metal back again and acrylic lip on the facet front. Pry open just adequate to make a room permitting the 2nd instrument to be inserted. Operate the 2nd device about the whole edge, which will trigger the metal back again to separate from the front. As soon as the back again has separated, turn the ipod more than and cautiously eliminate the back again cover.

Getting rid of the Battery

3 wires coated with coloured plastic insulation are soldered to the ipod and linked to the battery. These wires ought to be reduce with a knife or scissors. The cuts ought to be as around the battery as feasible to depart space for error. Strip the insulation a single/two inch from the end of the 3 wires soldered to the ipod. Consider out and discard the old battery.

Set up New Battery

On the new battery, there are 3 skinny wires that are stripped a single/four inch. These wires generally have white, orange and black plastic insulation matching the wires soldered to the player. Cautiously eliminate an extra one/two inch of insulation with out reducing into the wires. A wire stripper operates greatest for this job, but a sharp razor knife or scissors can be utilised. There are 2 techniques to connect the new battery. The initial entails twisting every set of old and new wires with each other by colour. Cover every set of wires with tape, generating certain no wire is left uncovered. Soldering the wires with each other is one more selection, but it is not advised due to the fact the warmth from the soldering iron can hurt the parts in the ipod.

Entire the Alternative

Lay the 3 sets of wires flat on the major board. Align the front and back again so the maintain change lines up with the circumstance, and the ipod will snap collectively. The new battery need to be entirely charged ahead of use.