Because of to its tiny dimension and sensitivity the display on your ipod nano 2G is susceptible to injury above time. A single frequent situation relevant to the display screen is connection troubles. You can resolve the display screen connection on your ipod devoid of the support of a services technician, but it will demand disassembling. You will not demand to know considerably above electronics in buy to do this, but you could in fact find out a tiny over your ipod in the approach.
Items You may Require
- Modest flathead screwdriver
Slide the "Maintain" change on the top rated of your ipod nano to the locked placement.
Insert the suggestion of your modest flathead screwdriver in the seam wherever the plastic panel on the leading of the nano connects with the back again. Gently pry up to pop the panel off of the ipod. Repeat the procedure with the panel on the bottom of the ipod.
Find the metal retaining bracket in the bottom of the ipod and pry it out with the suggestion of your screwdriver. This will expose an orange cable relevant in the vicinity of the bottom of the ipod.
Unplug the orange cable from its port with your fingers, found close to the bottom of the nano.
Use your screwdriver to take away the two screws on the metal panel on the leading of the ipod.
Insert your thumb or forefinger into the bottom of the ipod and gently push up. The internal parts will slide out of the best. Grab the circuit board from the top rated and eliminate the elements fully.
Raise the blue battery off of the circuit board and set it to the side of the board. This will expose the orange display screen cable which runs from the bottom of the display screen to the circuit board.
Guarantee the display cable is protected in the port on the circuit board by making use of your fingers. If it is not, eliminate it totally and plug it in, creating positive it is safe. This need to repair any display screen connection troubles. Reverse the methods for ipod reassembly.
No comments:
Post a Comment