Take Apart an iPod Nano 5th Generation

Understanding how to consider apart an ipod Nano fifth era can be a helpful factor. Whilst these iPods are recognized to be amongst the most dependable MP3 gamers, the fact stays that they are not ideal and issues can go incorrect with them. Anyone who has a small know-how around the internal workings of an ipod may repair numerous of the issues, but initial he should understand how to take the ipod open.

Points You will Require

Flat utility knife

Open the blade on the flat utility knife. The blade is generally no much more than a few of inches broad. A blade that is as well extensive might not work. Following the blade has been opened, location the blade into the side of the ipod. It need to match within of a tiny crack in the white (or black) plastic that safeguards the metal base about the device.

Right after the blade has been pushed in to the thing at which it can't go additional, start to gradually move the blade in a downward movement toward the within of the ipod. Slowly and gradually push the knife in deeper. If carried out properly, the metal that addresses the ipod will commence to separate from the plastic somewhat. This will depart adequate area for the knife to be able to slide among the plastic and metal.

Get started to move the knife downward slowly and gradually so that its blade commences to move upward (photo a lever). This ought to be completed little by little to stay away from breaking the plastic covering. There is an edge to the plastic that the knife ought to be able to grip.

Pay attention for the "pop." When that is heard, get rid of the knife from the ipod and set it to the side. Get started to pull out the plastic covering with your fingers. As extended as one side is out, the other side need to too arrive out relatively simply.

Substitute the cover. Soon after finishing the work that wants to be performed inside of of the ipod, changing the cover is rather straightforward. Making use of your fingers, slide one side of the plastic covering back again into spot at an angle. The moment the covering is in area, commence to push the other side down. Make positive the 1st side does not move out of area. Push on the two sides until finally a click on is heard.