Replace an iPod Nano Cover

Changing your scratched and scarred cover is like providing a clean paint task to your ipod Nano. Nano addresses arrive in a selection of colours and styles, permitting you to update your ipod to match your style. You can change the cover in a couple of actions. All you will require is a little flat-head screwdriver and a piece of skinny tough plastic these as a guitar select or tiny paint scraper to use as a wedge.

Get rid of the Back again Cover

Slip the wedge among the two items of the cover and operate it along the edges to loosen the casing. You can tape the edges of the ipod Nano cover to lessen the odds of scratching it in scenario you need to reuse it.

Pry the Back again cover off with the wedge. You may well want to separate the casing with the wedge to prop the casing open and the screwdriver to pry the items apart. Execute this action as gently as achievable so as not to disturb the internal wiring.

Disconnect the Difficult Drive

Take away the battery from the tough drive by gently popping it off the board with the screwdriver or wedge. The battery will be related to the tough drive by wires, so be mindful not to tear them. Spot the battery to the facet of the tough drive. If you are unpleasant functioning close to the battery wires, you can disconnect the battery entirely by pinching the best of the connector keeping the wires to the battery.

Unscrew the difficult drive from the front cover. There are 4 screws, 3 around the base of the tough drive in the vicinity of the synch port and one particular in the center of the board on the left. If the screws are coated by tape, Get rid of it. Elimination of the tape will not have an effect on the Nano's efficiency.

Disconnect the Front Cover

Flip the Nano over and gently elevate the cover up from the base. You are going to see a ribbon connecting the challenging drive to the front cover. Slide the black piece subsequent to exactly where the ribbon is related to the difficult drive--this will release the ribbon from the front cover, which you can now Eliminate.

Place the Nano Back again With each other

Connect the fresh cover to the Nano's tough drive by connecting the ribbon to the difficult drive and sliding the black piece into Area. Flip the Nano over and screw the tough drive Back again onto the front cover.

Reconnect the battery wires if you disconnected them previously. Substitute the battery in its challenging-drive bay and press down to snap it into Spot. Location the clean Back again cover over the tough drive and lock the two items With each other by pressing them firmly Jointly.