Remove the Battery in a 2006 iPod Nano

The Lithium-ion battery within your ipod Nano ought to final in between two and 3 many years of every day use prior to it requirements to be changed. Changing it via Apple is an costly proposition, but if you are useful with a soldering iron, you can change the component your self. Nevertheless, opening your ipod will void its guarantee, and if you need to set up a new battery, you will should purchase one from a 3rd celebration.

Issues You are going to Require

1st era ipod Nano ipod opening device or thin knife Soldering iron

Flip your ipod off and eliminate any addresses, cables or headphones presently linked. Location it on a clear, constant surface area. Flip the ipod more than so that the mirrored metal back again is dealing with up.

Wedge the separator device or knife into the correct aspect of the situation, exactly where the black or white front of the ipod meets the metal back again. Gently separate the two halves of the scenario. Following lifting the back again over a quarter of an inch, pay attention for the "pop" of the plastic tabs disengaging from the metal back again.

Pull the back again of the ipod off of the situation. Observe the battery (the only portion separate from the circuit board.) If the battery is bloated, warped or leaking, Quit. If you can see injury to the battery, contact your neighborhood hazardous waste recycling facility for disposal guidelines. If the battery seems typical, keep on to the following action.

Plug in your soldering iron and wait for it to warmth up. Right after 5 minutes (or Nonetheless extended it will take your iron to warmth), maintain the iron to the solder pad on the white wire connecting the battery to the circuit board. Maintain the iron in Spot for more than 20 seconds. When the portion compound is in a liquid state, gently pull the wire off of the circuit board.

Repeat Phase 4 for the red and black wires immediately adjacent to the white wire. When all 3 wires are free of charge of the circuit board, gently pull the battery off of the ipod circumstance (it really is secured with a tiny piece of tape on the opposite aspect.) Set the battery aside and unplug the soldering iron.